herunterladen
1
ISL6115A
12V Power Distribution Controllers
ISL6115A
This fully featured hot swap power controller targets
+12V applications. The ISL6115A with its integrated
charge pump has a higher (6.5V vs 5V) gate drive
than its sister part the ISL6115 making this part an
immediate efficiency improvement replacement.
This IC features programmable overcurrent (OC)
detection, current regulation (CR) with time delay to
latch-off and soft-start.
The current regulation level is set by 2 external
resistors; R
ISET
sets the CR Vth and the other is a
low ohmic sense resistor across, which the CR Vth is
developed. The CR duration is set by an external
capacitor on the CTIM pin, which is charged with a
20µA current once the CR Vth level is reached. The
IC then quickly pulls down the GATE output latching
off the pass FET.
Features
• HOT SWAP Single Power Distribution Control for
+12V
• Overcurrent Fault Isolation
• Programmable Current Regulation Level
• Programmable Current Regulation Time to
Latch-Off
• Rail-to-Rail Common Mode Input Voltage Range
• Enhanced Internal Charge Pump Drives N-Channel
MOSFET gate to 6.5V above IC bias.
• Undervoltage and Overcurrent Latch Indicators
• Adjustable Turn-On Ramp
• Protection During Turn-On
• Two Levels of Overcurrent Detection Provide Fast
Response to Varying Fault Conditions
• 1µs Response Time to Dead Short
• Pb-Free (RoHS Compliant)
Applications
• Power Distribution Control
• Hot Plug Components and Circuitry
Application Circuits - High Side Controller
+12V
-
+
PWRON
LOAD
PGOOD
OC
1
2
3
4
8
7
6
5
ISL6115A
+V SUPPLY TO BE CONTROLLED
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
| Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2008, 2010. All Rights Reserved
All other trademarks mentioned are the property of their respective owners.
April 23, 2010
FN6855.1
Verzeichnis
- ・ Konfiguration des Pinbelegungsdiagramms on Seite 2 Seite 3
- ・ Teilenummerierungssystem on Seite 2
- ・ Markierungsinformationen on Seite 2
- ・ Blockdiagramm on Seite 2
- ・ Typisches Anwendungsschaltbild on Seite 1
- ・ Beschreibung der Funktionen on Seite 3
- ・ Technische Daten on Seite 5
- ・ Anwendungsbereich on Seite 1
- ・ Elektrische Spezifikation on Seite 5
