herunterladen
February 2010 Doc ID 16982 Rev 1 1/48
UM0891
User manual
STM32100B-EVAL demonstration firmware
Introduction
This user manual describes the demonstration firmware running on the STM32100B-EVAL
evaluation board, which can be used to evaluate the capabilities of the value line
STM32F100VB microcontroller and on-board peripherals.
The STM32100B-EVAL board is delivered with the demonstration programmed in the
internal Flash memory, and all the files needed by the demonstration are programmed in the
MicroSD card. At each reset (board power-up, external reset, etc.) the demonstration is
executed.
In case the STM32100B-EVAL board was not factory-programmed or the demonstration
application was erased, the in-circuit programming (ICP) boot loader can be used to
program this file. For more details, refer to
Section 3: STM32100B-EVAL demonstration
package and Section 4: STM32100B-EVAL demonstration programming.
Note: Before executing the demonstration, make sure that all evaluation board jumpers are well
configured. For more details, refer to STM32100B-EVAL board jumper configuration section.
This demonstration firmware is available for download from the STMicroelectronics website:
www.st.com.
www.st.com
